EV Charger Installation in Sammamish
A Level 2 circuit sized to your panel's real spare capacity, routed the shortest sensible way and inspected before you plug in.
Get your charger priced — (000) 000-0000
The work
Charging at Home Without Overloading the Panel
A Level 2 charger usually wants a 40 or 50 amp circuit. Whether your panel can give it one depends on everything else the house already draws, so the first job is the arithmetic.
We add up the existing loads, allow for the charger and anything you plan to add, and tell you the result: a straightforward new circuit, a load-managed charger, or a panel change first.
For two years our workmanship on the charger circuit is covered under warranty. If a termination of ours slackens or the mounting turns out faulty, the return visit and the fix carry no labor charge. Hardware stays under the charger maker's own cover.
On the estimate
What the Charger Estimate Lists
Load calculation
The numbers behind the circuit size, written down so you can see why.
Circuit and breaker
Wire gauge, breaker and the charger connection or receptacle.
Cable route
Surface conduit, inside the walls or a trench to a detached garage.
Permit and inspection
Filing, the inspection visit and the sign-off copy for you.
On the day
How Install Day Goes
- 1
Power down
We switch off the circuits we are working near and tell you which rooms are affected.
- 2
Run and terminate
Cable goes in along the agreed route and is connected at both ends.
- 3
Test and hand over
We test under load, label the breaker and show you the settings.
Want this one priced for your house?
A free visit gets you an itemized estimate for exactly this job.